MIXING RATIO : The mixing ratio of these coatings are always listed by volume unless specifically stated separately, and are 2 parts component A to 1 part comonent B to 1/2 part Deionized Water. Mix component B into component A using vigorous mechanical agitation (ie: Jiffy mixer) to insure the proper incorporation of both components. Always use Deionized Water to thin the coating. These materials are sold in Kits. Kit sizes include:

1-1/2 Quarts - 1 Quart Component A, 1 Pint Component B
1-1/2 Gallons - 1 Gallon Component A, 2 Quarts Component B
3 Gallons - 2 Gallons Component A, 1 Gallon Component B

Larger volume packaging, 5 gallon pails or 50 gallon drums is available upon request.

APPLICATION : This material may be applied by any conventional spray method. Recommended atomizing air pressure should be between 35 - 45 psi. For pressure pots; Line pressure of 55 - 65 psi. , pot pressure between 6 - 15 psi. , atomizing air can be adjusted to desired pattern. Dry films should be in the range of 1.8 - 2.2 mils. to obtain the listed performance characteristics. When applying, do not exceed 6 - 7 wet mils due to the possibility of blistering with excessive one coat wet film builds.

CURING : At 77 F, sufficient cure will be achieved after 10 - 14 days. The coating may be force dried by heating in an oven at temperatures ranging from 150 - 220 F, and times ranging from 1 hour to 24 hours. Force dry these materials only after a 4 - 6 hour dry time at ambient conditions. A 5 - 7 day set cycle should be allowed before any testing is to be performed.

PRIMERS :

MIL-P-53022B TYPES 1 & 2

MIL-P-53030

DOD-P-15328 Green Wash Primer

Seafoam Green DTM Water Base Urethane

Zinc / Iron Phosphate Conversion

Most Anodize & Alodine Conversions.

For specific technical & performance specifications, please contact a Spectrum Coatings representative.

(401) 781-4847
Fax (401) 781-1075
Email: PaintMan97@aol.com